Niobium is a strategic material for Brazil, a country that holds the largest global reserves of this element. However, its sintering presents significant challenges, mainly due to the high reactivity of the metal, which promotes oxide formation and hinders consolidation. This study aimed to investigate the feasibility of cold sintering of niobium at different temperatures, seeking to minimize oxidative effects and enable new technological applications. The material used was supplied by CBMM (Companhia Brasileira de Metalurgia e Mineração), and experiments were conducted at temperatures of 125 °C, 150 °C, and 175 °C. To promote the formation of a transient liquid phase, niobium powders were mixed with 10 wt.% of absolute ethanol. Sintering was performed under a simultaneous pressure of 300 MPa, with a holding time of 30 minutes at each specified temperature. After processing, the samples were characterized through density measurements, scanning electron microscopy (SEM), and X-ray diffraction (XRD) analyses. The results indicated that cold sintering of niobium was effective even at the relatively low temperatures employed. XRD analysis revealed only minor peaks corresponding to the NbO phase, indicating a low incidence of oxidation during the process. These findings demonstrate the feasibility of cold sintering pure niobium, paving the way for the development of new components and applications, with advantages in reducing processing temperatures and preserving metallic properties. The use of cold sintering techniques thus represents a promising alternative for processing highly reactive metals such as niobium.